The guys at Rigid knew their lights were built to be tough but wanted to subject one to some real world challenges. They took on of their larger lights and started by dragging it around their parking lot behind a Jeep, then drove over the light a few times, and then took turns beating it with a 2x4 stud. The light looked ugly but still worked. Following that, they took the light to a shooting range and shot it with a couple of 9mm and .223 bullets, and then blasted it with a shotgun. The hex drivers in the light housing above show where some bullets went clean through the light. After all the destruction, two-thirds of the LED's still functioned!