The last night crawler in the box is the sway bar end links. With the steering up higher, it gets into the factory axle-side end link mounts. So, they need to move up too. This kit from T&T has a 3⁄8-inch-thick sway bar end link mount with a 1⁄4-inch-thick support tab, and it can be cut to length. Ideally, your sway bar will be within about 10 degrees of horizontal when the Jeep is at rest on level ground. If you can’t cut the weld-on mount to achieve that, you should look into modifying the length of your end links.