Subscribe to a magazine

New Seal Install

Back to article View Gallery
10 of 14
MIT used to rebuild a ton of these back in the day and even though it had been about 10 years since he rebuilt a Quadra-Trac, Sugg didn’t miss a beat. After inspecting the common wear points of our low-range assembly like the sun gears, main shaft, and internal splines, he reassembled our low-range assembly and then drove new output seals into our case. Then, the rear output shaft was fitted into the Mile Marker-supplied shift collar and installed in the case. Finally, the plastic thrust washer from the part-time kit is laid in place.

Advertisement