1999 Dodge Durango - fuel Cell - Photo 27385804

Back to Article

4. Since our drivetrain was pushed back roughly a foot, the stock fuel tank would no longer fit. With the decision made to create a fuel cell, we opted to place the new fuel holder in a similar location. This allowed us to use the factory fuel filler neck and breather tube that were already in place.

131 1001 01 z+1999 dodge durango+pull engine

1. The Advance Adapters four-speed transfer case is the proverbial Swiss Army Knife of geardriven torque dividers. While the bulk of the case is similar to the tried-and-true two-speed Atlas, the six-gear planetary underdrive attached to the front of the case makes the unit extremely versatile. It is fitted with a 2.72:1 low and 1:1 high in the forward planetary assembly, and we have the option of shifting from 1:1, 2.0:1. 2.72:1, and 5.4:1.

2. Each Atlas case is available in a variety of configurations and can be rotated flat for the ultimate in belly pan clearance. Our geardriven unit is set up for our '99 Dodge Durango's drive side drop configuration and is equipped with a 23-spline transfer case input. To allow the case to bolt up to our 48RE, a transfer case spacer, also from Advance Adapters, was implemented.

3. To shift the four-speed Atlas, we went with Advance's universal shift kit for the case and a cable shift kit for the underdrive. We'll show you more on how we mounted the lever configuration in a future issue when we start the reassembly of the Durango's interior.

4. Since our drivetrain was pushed back roughly a foot, the stock fuel tank would no longer fit. With the decision made to create a fuel cell, we opted to place the new fuel holder in a similar location. This allowed us to use the factory fuel filler neck and breather tube that were already in place.

5. The spacing between the framerail and rear driveline limited how wide a fuel cell we could create. Though we looked at increasing the tank's size vertically, we didn't want to hinder ground clearance.

6. Anytime you build a fuel cell it is important to place the fuel pickups at the lowest point possible. Momentum Performance fabricated our tank with custom baffles to trap the fuel and incorporated a set of Aeromotive AN fitting on the side for our lines to hook up.

7. To protect the 17-gallon fuel cell from damage, we fabricated a 3/16-inch steel skid pan that spans the length of the tank. To support the cell, we devised a custom strap system that uses the Durango's factory gas tank mounting locations.

8. Once the fuel cell was double-checked under the rig and tested for leaks, we sent it off to Area 51 Powder Coating to get a fresh coat of gloss black. With the tank back on the bench, we dropped in the fuel level sender that we had picked up from Summit Racing.

9. In order to accommodate the V-10's fueling needs, we used a Walbro high-pressure inline electronic fuel pump that has a free flow rate of 255 lph. A set of Aeromotive high-flow filters was placed before and after the pump to ensure that the external pump stays clean and delivers the fuel quickly.

10. The factory 8.3L fuel rail is a returnless system. This means when the fuel reaches the end of the rail, it does not continue to flow directly back into the tank. To ensure the correct amount of fuel pressure, but excess fuel can still flow back into the cell, we used an Aeromotive 13109 bypass regulator (arrow). To finish out our fuel system, we used Aeroquip stainless steel braded -6 lines to tie-in the rail, regulator, and pump along with an assortment of AN fittings from Russell and Aeromotive.

131 1001 07 z+1999 dodge durango+summit products

131 1001 13 z+1999 dodge durango+shifter