Once the inside diameter of the tire’s bead is around the machined shoulder of the wheel, you can install the beadlock ring. Place the ring on the wheel and hand-thread each bolt, with a washer, into its threads. Once all the bolts are on the wheel, you can take a ratchet and start tightening the ring slowly. Tighten each bolt slowly in a star pattern so the ring stays flat and is evenly tight all the way around the wheel. Once the bolts start getting tight and the ring is nearly touching the wheel, torque the bolts (in a star pattern as before) to 20 ft-lb each. This takes a while, but it is important to not over-tighten the bolts. Otherwise, the tire’s bead will be in there crooked.