Click for Coverage

131 0306 Heat03 Z - Photo 9011860

Back to Article

Header wrap stays in place with these cool-looking Thermal-Ties. The wrap can handle a continuous 1,000 degrees F so you don't have to feel the heat. The exhaust heat stays inside the exhaust system until it gets closer to the tailpipe, keeping components that are close to the exhaust much cooler.

131 0306 heat01 z

131 0306 heat01 z

On our '71 Bronco we've got fuel and electrical components as well as vital shifting cables sharing oven space with the exhaust and drivetrain. Header wrap was installed first to try and keep the heat contained until it got farther along in the exhaust system. High-horsepower engines produce more heat than a stock unit, and our built 302 is no exception.

Header wrap stays in place with these cool-looking Thermal-Ties. The wrap can handle a continuous 1,000 degrees F so you don't have to feel the heat. The exhaust heat stays inside the exhaust system until it gets closer to the tailpipe, keeping components that are close to the exhaust much cooler.

The muffler needed a heat barrier with an air-gap above it, so we used pop rivets to hold this Reflect-a-Shield to a rigid panel. This material can reflect temperatures of 2,000 degrees F continuously. This is just the ticket for catalytic converters and other big heat-producing components. We installed ours to reflect heat down and away from the passenger compartment.

These 3-foot lengths of aluminized cloth can be pulled over the fuel lines and wiring harness like a long protective sock. Cooler fuel has less chance of boiling and causing vaporlock. Fuel pump cavitation due to boiling fuel is a leading cause of pump death. We also cut pieces of Reflect-A-Cloth to wrap individual components as needed. The fuel pump and bulky wires were wrapped in place with multiple layers of the stuff. Electrical components are more efficient at lower temps, thereby drawing fewer amps from the electrical system. This rig was later romped on for a week in the desert at temperatures far exceeding manufacturer's specifications. We finally burned up a fuel pump relay under the hood, but everything that was protected is alive and well.

Let's face it, every hole in the firewall turns into a blowtorch on a hot day. Duct tape withers and blows away, but this adhesive-backed Reflect-A-Tape makes a quick yet lasting barrier to engine heat. It can also be wrapped around shifter cables and other hard-to-reach areas. We amazed a buddy with a Jeep by how fast we could make his rig comfy. Purists will be delighted to know that the tape can be painted to make it look factory cool like this olive-drab '47 Willys.

We finished off our heat problems with this kill shot. A 40-inch-wide section of Reflect-A-Cloth is available in any length you want. We cut ours to fit the transmission hump and had a canvas shop sew the pieces together. We mechanically fastened ours with rivets, but a high-temperature contact adhesive will also work provided the surfaces are clean. We positioned this barrier under the complete cabin for a huge improvement in the cool factor.

We used our cool Raytek Mini Temp infrared heat gun to measure the temperatures before and after each upgrade. The gun is inexpensive, easy to use, and very accurate and has multiple uses for other projects in the works. We found temperature drops of almost 400 degrees F in the muffler area, although we didn't need the Raytech to figure that out.